Home
Radios
  Bekius
  Belgian battery radio
  Braun
  Larsen de Breij & Co
  Bush
  Cadčne
  Cossor
  Curry
  Ducretet
  Ekco
  Emerson
  Emud
  English console radio
  Erres
  Fada
  Gamage
  General Electric
  Grammont
  Grundig
  Haagsche Radio
  Onderneming
  Van der Heem &
  Bloemsma
  L'Indiscret
  Kennedy
  Larret
  Lorenz
   DKE38
  Marconi
  Mende
  Mildé-Bayard
  Monarch (France)
  NSF
  Het Oosterpark
  Orion
  Péricaud
  Philips
  Pye
  Radio-Compagnie
  Amsterdam
  Radio Lucien Lévy
  Rega
  Schaleco
  Seibt
  SFR
  Telefunken      
  Telegrafia
  Tesla
  TinyTone
  De Tijdgeest/Airvoice
  Unigro
  United Engine Co.
  Verwer Radiobouw
  Videoton
  Waldorp
  Weco
  Westinghouse
  Zenith
Loudspeakers
Other items
Valves
Nostalgia
Links
For sale

 
Deutscher Kleinempfänger (Small German radio)
TRF receiver with reaction control with brown bakelite case and cardboard back. Made since 1938 by a number of companies in Germany, Austria and Poland. Lorenz came up with the best design of a low-cost radio and also played an important role in its further development. The receiver only has two valves: the rectifier VY2 and the VCL11 triode/tetrode. Hungary had its own version of the DKE, the Orion 011 Néprádió.
Nick-name for the radio was "Goebbelsschnauze", or Goebbels' snout.
The left knob operates the input coils coupling, the right knob operates the reaction variable capacitor. In the middle the tuning knob with a 0-100 scale in white (200-600 meters) and red (800-2000 meters). By turning the tuning knob to the red part of the scale, the radio switches from medium to long wave.
There is also a battery version. An identical version of the radio, the DKE50, (without the eagle and swastika) was produced after the war until 1950.
Data Valves
Serial number: 8192
Dimensions (w×h×d):  24 × 24 × 12 cm
Made in: ± 1938
Purchased in: 2011
Weight: 1.6 kg
Click on a valve for more information
Circuit
Back with back panel
A look inside
The loudspeaker is made from synthetic resin bonded paper.
On the right the silver coloured VCL11, on the left the smoothing capacitors and the VY2 rectifier. Below the smoothing capacitors a simple on/off switch is visible.
Operating voltages (110-130, 150 and 220-240) can be adjusted by using the taps of the ballast resistor in the middle.
Four sockets for antenna and earth (left) are situated below the ballast resistor. An adjusting screw for grid voltage is situated between the on/off switch and the sockets.
The chassis
Top and bottom view

This page was last edited on 27.04.2012